How to Change a Skagen Watch Battery

Posted by Alan Almirol on

Watch Brand: Skagen
 
*Video and battery installation applies to all Skagen models*
 
Watch model shown: 233SSSB
 
Tools Used: Bench Knife (KNF-967.000)
Instructions:
 
Step 1: Find the removal ridge on the case-back of the watch. Wedge the bench knife into the removal spot, and pry the case-back piece off of the watch.
Step 2: Use the tweezers to remove the old battery as well as the gasket located on the inside of the case-back piece of the watch.
Step 3: Use the tweezers to correctly put the new battery in place; use the tweezers to place the gasket in the sealing grease lubricator (to ensure water resistance), then place the gasket back around the inside of the case-back piece.
Step 4: Place the watch firmly on the crystal press tool. Line up the case-back so that the inside curve lines up with where the stem is visible (so the case closes properly).
Step 5: Use the crystal press tool to clamp down on the case-back piece to firmly seal the watch.
Looking for a Skagen Watch Band? Click Here
 

Share this post



← Older Post Newer Post →


nawcc
awci
100% satisfaction